US Indy Mags

Help Support 7173Mustangs.com:

PeteG41

Well-known member
Joined
May 18, 2022
Messages
160
Reaction score
52
Location
Tempe, AZ
My Car
351c 2v, FMX Transmission. Ordered from Sanderson Ford in Phoenix, 99k original miles.
I replaced the lug nuts on mine, and still have the old nuts and the locks.
Just checked, and these have 11/16 shanks. You can have 'em if they'll help.
These are the ones I replaced.
View attachment 63826
Somehow didnt notice you mentioned you had some older ones you took off. Once I get mine measured ill shoot you a message to see if they will work!
 

PeteG41

Well-known member
Joined
May 18, 2022
Messages
160
Reaction score
52
Location
Tempe, AZ
My Car
351c 2v, FMX Transmission. Ordered from Sanderson Ford in Phoenix, 99k original miles.
Got a lug off…not quite sure why there are 2 washers though? I was under the impression there was only supposed to be one. Went to orielly, and I’m sure this is a very stupid question so bear with me, but will these work? Almost exactly the same length, my old one just has that slight taper
 

Attachments

  • image.jpg
    image.jpg
    2.8 MB · Views: 11
  • A4334591-8F4E-4170-89E4-2F4DAA6DB795.jpeg
    A4334591-8F4E-4170-89E4-2F4DAA6DB795.jpeg
    1.3 MB · Views: 9
Last edited:

1973 Mach-1

Active member
Joined
Jun 29, 2016
Messages
31
Reaction score
22
Location
Phoenix AZ
My Car
Arizona car, 1973 Mach-1, Still has its original 351 Cleveland engine and its original C-6 trans, All original body panels, most of original paint. Interior is restored.
They probably used the two washers to make up for the fact that the shank was a bit too long. You may still need the second washer.
 
Top