Bentworker's latest activity
Help Support 7173Mustangs.com:
-
BToday I tackled replacing a stripped wheel stud, but the nut on the hub is 1-1/8” and I did not have that size socket, so I ordered one...
-
BHere’s mine
-
BDone with the springs. What a royal pain in the ass. The new lower perch bushing is pretty tight and makes the install of the new...
-
BBentworker replied to the thread Off the shelf 3rd member that drops into our cars?.Ok- the whole flange gasket subject has me thinking. The gasket does not seal anything- but it does control how much endplay the axle...
-
BBentworker replied to the thread Off the shelf 3rd member that drops into our cars?.No flange gaskets used. When you are running a sealed bearing with a seal inside the axle tube no oil is getting out to the flange.
-
BBentworker reacted to Hemikiller's post in the thread Off the shelf 3rd member that drops into our cars? with
Like.
The one in the video is the later Big Ford end. The parts you have are correct. -
BBentworker reacted to Sheriff41's post in the thread Off the shelf 3rd member that drops into our cars? with Like.
Those are the ones. The axle bearings are enclosed bearing (bearing and race as a unit) and are pressed-on the axle and held in place...
-
BI found this site that has a ton of information on Fords. Lots of basic technical shop training manuals. It takes some time to open each...
-
BIt’s ready for the road….I will of course do small tweaks forever….started with a 71 Grabber Blue 302 C4 PS PB AC car…
-
BBentworker replied to the thread early "71' only" dash pad.Can you post some pics showing the profile from the end? That might settle the debate if it was an extruded part or not.
-
BBentworker reacted to Sheriff41's post in the thread Off the shelf 3rd member that drops into our cars? with Like.
I hadn't heard the Truetracs whine. I'll have to listen closer to mine. I have Truetrac with 3.89:1 gears.
-
BOoops, I could and should have provided a schematic so you can double check the wiring and voltages. Here you go, from a 73 schematic...
-
BBentworker replied to the thread Can someone with a 71 grab me a measurement?.
-
-
BBentworker replied to the thread Can someone with a 71 grab me a measurement?.What are you guys hooking the end of the tape measure on?
-
BToday I started on the springs. Decided to do the right side today and the left tomorrow. But when I took out the original spring the...
