Recent content by dON

Welcome from Cape Cod

Welcome Enjoy the site, Lots of great people and info!

Welcome from Cape Cod

I Run BF Goodrich on all my cars and my Dually

Had to replace hose's and nozzles, as mine weren't put back on during a recent overhaul, got all partrs works well, but as said, havent used much, except got caught in shower coming back from a cruise

72, Q Code 351

all set thks, pin bushing on the caliber installed incorrectly, thks

thks for all the info, believe it of not, when I pulled the wheel, looked at the caliber, the bushings were there, I tapped the caliber with a dead blow hammer, heard the noise, pulled the first pin, and you wont believe this, whoever replaced pads etc, pur bushings on end of pin, instead of...

Thks, found the caliber kit at O' Rielys should have tomorrow, thks again, what I have found is a lot of little things that wern't done right the first time, add up after a while, finish this and put new Ujoints on Driveshaft, and should just take care of about 98 percent of the rattles. who...

You wouldn't happen to rem part number would you, I believe I have the same issue with my 72 mach

Thks for all the input, have had my car since middle of june, 2023, have had, front end done, replaced ball joints and tie rod ends, aligned old fashioned way, but still have the right front rattle when going over man hole covers on resealed cracks in road, but goes away if i am on the brakes...

Great job always a process enjoy

I just recently bought a 72mach1, that was wired all wrong, as stated before, on the regulator, the orange blue wire is the field wire to the alt, check with volt meter, with key off, it should read 0 volts, turn key to on position, should read battery voltage, found on my car that the alt...