Recent content by GrantOv

They are more like wet wipes. https://www.menards.com/main/tools/automotive/automotive-cleaning-detailing/cerakote-reg-ceramic-trim-coat-restoration-kit/ah-trkit/p-1642874305835869-c-9102.htm

For the 740 - I had a question. What you you recommend regarding speaker wiring for dual 4ohm voice coil dash center, 4ohm R&L door speakers, 6ohm R&L rear speaker and powered slim subwoofer? I think RCA to the sub, straight wiring to the side and rears but not sure how to handle the center...

Just a thread to call out some good results from products we purchase. Hopefully, this can focus on the consumers vs. sellers. And as I've been reminded - please post pictures! I had better than expected results this weekend using Cerakote plastic trim restorer/rejuvenator - or whatever...

Would you mind sharing a picture of your new door baffle boots installed? Did you take your door off to drill out the new boot holes?

Your solution is fire! I didn't think it would fit there but perfect! I think that was one of the slimline subs I was looking at also. I may DM you a few questions when I get closer to the install :) Got to read your posts first and digest them though!

I think ensuring holding down the speakers is a great reminder. No problem with a couple small screw/bolt holes - I'm just working to avoid large speaker cutouts. Looking at enclosed speakers also so the sound can be as designed vs. dependent on the installation cavity. I'm still weighing...

I just watched the full end chase scene - easily #1 in my book!!! Link for others -

Has anyone installed these door panels. The texture print in the vinyl looks interesting but not sure how they look when installed. I'd love to see a picture if you have one! I had thought about adding some carbon fiber print around my gauge bezels since they need replacement and thought that...

This may not be everyone's cup of tea but I've thinking of what to do for speakers in my Mach1. I don't think I need something over the top but would like to reasonably augment the door and front dash speakers. I was thinking of building 'corner' boxes on each side of the trap door but then...

All went together great - I added some neoprene between tank and body as suggested also. Thanks again for those that helped with comments.

I finished installing the new door and window weatherstriping and see that on my passenger door the window doesn't press firmly against my rear fixed window vertical weatherstrip. There is a small gap. This was an issue both before and after I replaced the weatherstripping. It appears to me...

I am preparing to install some ACC EVA backed sound deadener and ran into a question. They only sell one kind on their website and don't have much for instructions accept - "install poly side down/paper side up". No video or instructions online to help guide and they close shop at noon on...

Just a quick check - on the filler neck gasket there is a flared or beveled side - should this go 'up' or 'face inward' to the tank?

Thank you for this detail - very helpful to understand the the level of effort and rework. My takeaway is that it appears that while there may be a few common parts there are very few, and that there are door metal modifications along with some careful panel modifications. The other key...

My door panels have seen better days and I like the look of the deluxe panels. I understand I'll need to lower my door latch. Are there any other gotchas I should be aware of? Is there a vendor of replacement door panels someone would recommend for a 72 Mach? Are there clips I need to add to...