1971 Mach 1 super COBRA jet with drag pack . This stang was completely under water during hurricane IKE here in South Texas. Car underwent hundreds of hours of restoration. Repainted in original factory Wimbledon White with factory green standard interior
Is ther anyone out there making reproduction wire harness for our 71-73 Mustang clock and console ? Some ebay vendors are selling many reproduction 71-73 Console's. They look good but they don't sell reproduction wire harness to go with. I have looked for used ones on Fleabay and can't seem to find
HI just joining the conversation. My car was completely under water back in hurricane IKE . Luckily my engine was out at a engine shop and remained high and dry , but my steering box was under water and I am sure I got water in it. Now I need a new steering box. You say you got 3 NOS steering...
Thanks for your response. Do you remember if your shims were Flat or did they have a curved end. All the ones I have seen on ebay have a curved end. Seems to me that due to the big drop from the seat platform to rear floor a all flat shim would be better
I just replaced my carpet and I don't want to rip the new carpet sliding my seat Back and forth . I did not see any shims when I removed my seats. Did our cars originally come with shims? I can't find any original shims on ebay for 71-73 , just the older stangs. I'm wondering if we need them...
GOD BLESS YOU ! I Just went through a box of extra leftovers and found some extra splash shield screws which looked like the photo you posted. Turns out they are the same and fit perfectly. Thanks again for your assistance. I posted photo
Does anyone know where I can Buy the 2 bolts that hold on the fresh air knob bracket to the lower Dash . Can't seem to find anything useful at Home depot. Someone has to be selling these for 71-73 stang. I have attached photo on the bracket with knob.
Does anyone know what opening in my firewall the speedometer cable goes through. Can't seem to find a 71-73 Mustang firewall diagram on line. I have attached photos of my firewall . I have it narrowed it down to 2 holes , maybe the one close to the power booster or the hole farther left of...
Hello, I need a new steering box too. I have been told by a repair shop that they would have to remove the engine to get to the Box. I was wondering if you removed your engine to replace your box. Thanks
Thanks for the help Randy , I sent you $20 PayPal For lunch on me . Maybe Casa Molina Mexican restaurant? I got one more wire I can't seem to find out what it's for ? Located above glove box too. Check the photo, thanks ,