Recent content by Jack

I thought i had a good machine shop till I found out they send out their balancing. I also took for granted the boring was done right. I'll check the tapper I did the gapping for rings. First time Ive done that. ill check those to be sure. I took my time when I did those but here I am so right...

Heres the update...but first thankyou for all your ideas. I did a bleed down test holy crap it was every where and not within 10 or 15 % diffrence. Found 2 valves are sticking (after heads redone second time) Going to lap them and hope for best. I have full 12 volts at coil start and run...

Thankyou much definitely didnt think to check constant voltage. I ASSUMED Will check after dinner tonight.

I rebuild a 1971 Ford Mustang Mach 1 351 Cleveland 2v heads roller chain decent cam I don't remember the exact specs on the can bored out 30 over with roller rockers 1.73 new push rod 150 compression all the way around New MSD ignition and coil I put cvf racing water pump and front serpentine...