mrgmhale's latest activity

I am dead center in the, "check the wiring," camp. Be sure to look at the gound cable from the battery. The ground cables I use has an...

I also run Autolite 24's and gap them to .040. Your ignition system will play a role in how wide you can gap. Engine masters did a...

No matter how they seem to be, it is good to pack them, and replace the grease seal, any time you do any kind of brake work. They are...

There is a master cylinder for cars with disc brakes and a different on for cars with drum brakes. Happened to me years ago. The parts...

I ran an original Holley 4010 for many years on my 71's 302. This is the carb that later became the Summit M6008 series, It was the 600...

Carb choice, everyone ( who has a few grey hairs on their head) has had experience with carbs. The overwhelming choice for performance...

With good breathing engines (like the 351C) I have found 750 Vacuum Secondaries (VS) to work well. Those VS systems do a lot to forgive...

Most Clevelands can handle more than the 600 cfm most calculators recommend. I ran a 750 Holley with vacuum secondaries, the engine shop...

Our Holley 750s are vacuum secondary (VS), and have no secondary accelerator pump (aka "squirters"). I figure they are counting on the...

That's the one I have on mine, it runs great and love the warranty that Summit has on their carbs. I got one and it seemed like the...

We all started at zero. I had a couple hundred in gifted Craftsman tools and a Haynes manual when I started in '89. Today, you have the...

Great story, Mr. Hale! When my shop teacher first talked about taps, he said the most important thing is to back off every 1/4 turn to...

Cost savings - same casting, side specificity depends on how it's machined. Ford used these on the 68-73 Mustang/Cougar and the 68-71...

You got to admit Ford did poor design on this. By just moving one bolt hole inwards into the casting and the bracket this would never be...

all set thks, pin bushing on the caliber installed incorrectly, thks