Paul M's latest activity

I didn't like doing these back pcs since they all sit on concave surfaces. These outside decals were matched up to the other, taped in...

Even though I used the tape to hold it in place on the bottom, I sprayed the whole thing w/ water and 1 drop of dawn dish soap pr/bottle...

On the back decal, I trimmed it tight so that I could see where I put it. I trimmed the keyhole area with curved surgical scissors. I...

These were put on dry. The vinyl on the rear (trunk lid area) and very front fenders, will need to be put on wet because of the multiple...

Squeegee these well, anything w/ different angles from the direction you pull it will want to lift.

This only works after you've pushed everything down w/ the squeegee. Letters are where it will lift the most.

I can't find the correct picture. This is an important step. Use the squeegee from the bottom up & the middle outward. Do not let...

By doing these dry, you've got one shot. Also subject to more air pockets. Some small air bubbles will disappear while others can take a...

Use 3m painters' tape & clean the area w/ Windex so that tape sticks.

Then I taped the bottom w 3M painters' tape, in the position I wanted.

On the large side decals for the 73 Mach 1, I went with the "dry" method. I trimmed the bottoms of the backing paper even all the way...

I like the vinyl graphics on this car, anyway back to the Mach 1

I continually sprayed allowing me to work out the air pockets, while repositioning what I don't like.

I trimmed it pretty tight and kept it wet.

On the ol' Dodge I kept the whole quarter wet to apply the vinyl.