Search results

To get the emblem in, I used a heat gun, but you have to be careful and keep moving the gun. It’s a tight fit. For the chrome strip I used 3M aluminum foil tape, it’s a good product, sticks well and still looks good after years of use.

Did you sell the dash pad

You can’t always get what you want but if you try sometime you just might find you get what you need……Rolling Stones In 1981 I purchased my 1973 Mach1, not the most popular car at the time, I learned and restored this car into what it is today, added fold down rear seat, am 8track, rim blow...

Agree with the above comments, replace the voltage regulator

I removed the origin coating with oven cleaner, tapped out any dents and began sanding and polishing. Very time consuming but well worth the effort. I did not anodize the aluminum but clean it and wax it. It has kept well for many years

Yes it is, As Spike stated most new sets will set at 0 degrees dot to dot, just install a good double roller set

Yes, I never changed cams

A good intake and 4 barrel carb should do well for that car. In 73 the timing was retarded 4degrees, if you add a new timing gear set and set it to 0 it tends to wake up the Cleveland , sure helped my Q code

They look great and will be a nice addition to your car

I like it, nice Job

You can bolt on a little piece of metal to extend the tab on the door mechanism for the deluxe door panel release

Due to the rarity of avocado interior parts Any pieces That you do purchase will probably not match anyways due to wear and fading. when I redid my deluxe avocado interior, I purchased a new set of white deluxe door panels, used black dash pad, replacement hinge covers. I then collected all the...

I built my own as well using the plastic cover plate and a piece of white plastic lampshade that I had kicking around. I located the switch in an old parts bin at a store that repairs old electronics. Guy gave it to me, then I hooked up a battery operated light. The light can easily be removed...

As stated earlier the carb sits to high, so I had a thinner billet plate machined to replace the EGR plate cover the channel in the intake nicely and lower the carb, I could then use my K&N filter.

summit has them

When I installed the ram air the the air cleaner was to high so I had a billet plate made to replace my egr plate for my 4300D. This has worked well for years and although the 4300D was difficult to tune, once dialed in it has worked well for me. Maybe a plate could be made to accommodate a...

Think your on the right path with a wire issue, just went through this issue myself and found it was a sketchy ground cable at the battery that caused the same types of issues. 351C with Pertronix Ignitor I, Accel Super Stock 8140 coil.

As you mentioned the OEM ones are 5 screws with the horse tail within the boarder. Many people at car shows will not distinguish between 5 and 3 screw type centres (many people don’t know that aluminum rims were the only mag optioned in 73) so it all depends on where you show the car and your...

put a fold down seat in this Mustang several years ago, takes a bit of work but the biggest thing is getting all the correct parts needed. As far as the car your looking at, I’d stay away as to many things can and will be hidden with a fancy paint job and bondo. I‘m fully restoring a 68 Mustang...

Back after a little time away. Will certainly keep up with the posts more. Can’t wait to get her out again