Search results

Got it working tonight, when I set the dash back in place, the main harness that goes behind the cluster got pinched. There is supposed to have a plastic routing sheath but that's long gone that the harness goes through and is protected. I loosened everything up and was able to move the harness...

Thank you Gil, I really appreciate the files and will definitely be using these for troubleshooting. Tom

I disconnected the plug at the sending unit and the gauge continued to peg out. I then disconnected the rear harness at the kick panel location and the gauge still pegged out. I will pull the cluster and start checking it and all of the wires at the harness. More to follow and thank you for the...

Thanks Randy, I was hoping that you would we respond quickly. I will check that tomorrow and report back. More to follow. Tom

For those who have not seen my dashboard swap, I successfully swapped my spare dash but for some reason my fuel gauge now peges our all the wY . I checked my grounds to body and they are good. This was not an issue 2 or. 3 weeks ago before the swap. Thanks Tom

Just to add to this thread, I went through the process of changing out my dash. Got the center armrest/console installed with the dash but for some reason the gas gauge is pegging out at max now. I have checked grounds and other tan that nothing has changed. Thoughts? Thanks Tom

When I replaced my front windshield, the mounting plate was already attached, maybe molded into the glass during production. It may not be as easy as just heating up the mount, be careful. Good luck, let us know what you end up doing and how it goes. Tom

Thanks everyone for the offers, after searching late last night, I found one and ordered off of ebay. Should be here by Friday. I will let everyone know how the replacement and the dash install goes. Thanks. Tom

I was thinking the same myself, thank you for the advice. Tom

While putting my dash back together, my heater/AC control fell off the table. Below is the disk that came off. Can I repair this and how? Thank you in advance. Tom

Does anyone have a pic of a corectly installed below pic? Thanks in advance. Tom

Thank you HK, no idea why it wouldn't come up for me on their site, I searched for about an hour. I will keep and eye out for when it comes back in stock. Thanks again. Tom

Thanks for the comment and advice Gil, I appreciate and always pay attention to your posts and videos. I picked this up used from a member here and I believe it to be an original part but will surely figure it out. I will give my extra dash a try to see if there is any difference and report back...

I have a spare dash but around the glove box are holes for a bezel. That’s the best way that I can describe it. I used to see these for sale and apparently my Google-Fu is not up to standards anymore. Does anyone have a source for me to buy one? Thanks. Tom

I will snap some more pics this week and post them, tonight I am going to dig through my storage unit for my spare dash. More to follow. Thanks. Tom

Thanks Buckwheat, that gives me an idea that I will have to check tonight. The short console fit perfectly, I am going to measure underneath the short console and then under the long console to see if there is a difference. It may be as simple as spreading the sides out a little more to get it...

70cobrascj, the shifter (stock) is mounted in the stock location, I added the red markings to let me know when it was actually in the right position for that gear so that I can get it adjusted correctly. I have used the manual directions many times for adjustment and every time that I am under...

Thanks Eric, without the long console in place the center stack and bezel fit properly and not "flexed" against the metal dashboard. The bezel and everything fits with the double din radio as well, I will take a look at the dash itself this weekend and see if it is out of place or misaligned. if...

Bobby, I have the FMX transmission. Tom

HK, that was done when the double dinn radio was installed. That modified plate, radio, heater controls, and center stack bezel fits perfectly with them installed and the small center console around the shifter. If I can’t get this all fitting with the new console, I have a spare unmolested dash...