Search results

Took my yellow out. Found good agle to capture it all

Heres a picture that someone took during car show/cruise and posted on FB...after that, i had to fix it :)

Today i realign grill and mounted new front spoiler (concourse quality) as the old fiberglass was deformed (see pic above, hang low on driver side). Still have to realign bumper.

Now you are making me hungry, as i am shopping at the grocery store....

I had replaced few dashes in my stint rebuilding salvage cars - dont like doing it one bit.

Put tube doors on the Jeep. Kids were too scared to drive without doors.

It was nice cool evening so desided to take blue thunder to lake Michigan (10 min away from house)

Went to lake Michigan dunes

Sounds like a solid 12k - 15k car and still good deal at that

He can sell ot for 10k in 2 days might get 15k if waits for the right buyer. 20k would be sitting and never sell. 7k would be killer deal, if he wants to. I got 71 fast back for killer deal....maybe he can get someone happy.

Final product mounted. And car driven from hybrination to 1000+ car show. Also first time both Mustangs met, as they are stored in different locations.

Ok, the top half of the back seat now have original vinyl over new padding and painted frame. Planning to repair hole.at the bottom with plastic repair kit.

Seat has broken wire, so if anyone knows its purpose - let me know please. I did connected wire retainer incorrectly in the picture.

Today I mounted repaired original upholstery on bottom cushion....onto repaired and painted spring frame.

I did also have shop saw in new fabric on one side which tucks around frame.

Finaly had some time today to finish rear lower seat. I have completed the following to rebuild seat while reusing OEM upholstery: Painted frame, reused wire/suntetic mash, padded with 1" foam + 1" super fluffy cotton + 1/4" cotton sheat. Used 1/4" felt in the center bump and sides. No foam...

Ok, I rebuilt carb with new gaskets, cleaned up fuel deposits, set fuel floats, adjusted idle screw to have transition slot square and adjusted secondary butterflies to slightly open to get idle at 900-100rpms when hot. Also connected plug wires in correct order! Previous owner mechanic really...

Now I need to check how mine is mounted....probably just velcro

I opened um my Holly carb to check on floats, gaskets and set idle transition, set floats paralel the ceiling. Float bowl does not tilt down much because a rubber nipple is propping it up - is it normal, or should I trim it? Also there was a good amount of dust like build up which clean up...

My car ran out of gas while warming up. I filled it out of the can and drove it into garage, not enough to see. Idles fine. I am planning to change out carburetor gaskets and rebuilding carb this coming weekend. So will drive car right after that.