Search results

Factory competition also looks like the one on the right.

Mach 1s with the 3/4 vinyl roof used an extra roof brace directly below the rear edge of the vinyl to help support the roof panel when pushing the moldings down to snap them into the molding clips. This may be such a roof brace. It runs across the inner roof aligned with approximately the back...

Letricegg, I just sent you a private message on your console latch inquiry.

Steve, $20 total

No bottom pieces, AC parts you want would be $350. Sent you a text with photos of windshield trim and air cleaner lids.

Jon, here is the AC stuff.

Steve, here is photo of it with 12V applied, light works. The stock ash tray has little window openings that line up with the light that shine in from the shifter side.

I have the two harnesses shown in the post. You would need to splice them together to make the harness you have in the picture you provided. It should fit the long console, but you should check if it is long enough to comfortably reach the mounting position in front of the ash tray when...

I sent you a private message on these.

I have 4 sets, here is a photo. Some have black window sealer on them and some have some dents.

Pictured is a racing mirror set I have available. $125 plus shipping. I have the base gaskets for them also and will include them. Please use the start conversation tab at the left when you hover over my info if interested.

Pictured are the console parts I have available. Clock wiring, $25, ash tray light $15 (you would need to splice it into the clock lighting wires). Shifter surrounds $10 to $30 based on condition. Console lids $30 each. Ash tray sliding door assemblies $15 each. Storage compartment $25...

I sent you a private message on rear defrost switch

I have only the rear passenger side panel left. It has the rectangular hole for the ash tray and the opening for the power window switch. You would need to transfer your wind lace and window felt/ chrome edge over to this panel.

If the casting numbers are not that important to you, 351 C 4V manifolds can be easily bored out to 2 1/4 at the connection to the "H" pipe opening by a machine shop.

Sorry, rear bumper guards are gone.

I have a new set and never used if interested.

The examples I have seen thus far on this forum with the painted to match the stripes front marker light area also have the Tu Tone hood. Makes me wonder if it was only done in conjunction with the Tu Tone hood as the body paint department had to paint the argent or black on the hood anyway and...

The front edge screws to clips on the seat back lower hinges (not the long upper chrome hinge). The rear screws to tabs that are part of the fold down trap door hinge arrangement. The screws are Philips heads with a countersink type washer. The tray (load floor) have holes in it where the...

David's car is brown. The photo above appears to be from a blue car (given what appears to be a blue door jamb). The 5H code being for brown. Mystery.