Search results

Also the firewall holes are different for the heat/ac box and lines. Heat only the hose lines came thru the firewall high up just below the panel pinch weld. Heat/ac cars the lines come thru the bump out in the firewall and the hole is much larger with a large seal gasket. Very obvious firewall...

That's just a Ford Motorsport sticker put on the fender that came from somewhere else. That fender's been on a car, for a while. Look at the back side and you see the road dirt. Also the fender has been painted and the paint is fairly chipped. It might be an OEM Ford fender, but it's not NOS.

Welcome from the Republic of Texas!

Right on KC. The vacuum canister is a reserve tank usually with a one way valve so it holds a reserve when the dash pots move and need a volume of vacuum. Sent from my SM-N900W8 using Tapatalk

It's a rear vent hole for excess pressure Sent from my SM-N900W8 using Tapatalk

Looking for picture (s). Don't see any attached Sent from my SM-N900W8 using Tapatalk

If the top of the fenders were also blacked out, maybe it wouldn't be so hideous.

Hello Ozzie! Welcome to the site from the Republic of Texas! Thank you for your service as a fire fighter.

There are a lot of things wrong with that car. No factory ram air on the 73 cars due to emissions changes. The air cleaner is from a 72, the 73 air cleaner has the tube duct feed from under the battery tray. Wrong side stripes as mentioned paint looks too fresh to be original. Rear spoiler not...

They are Kelsey Hayes brake drums, one of the OEM suppliers to Ford. The A71 and P171 are date codes for when they were cast. Might be service replacements.

Welcome from the Republic of Texas Sent from my SM-N900W8 using Tapatalk

After it dies after running for 20 seconds, pump the accelerator and look into the carburetor bores to see if fuel squirts. If it does, sounds like your carburetor idle circuit is clogged.

Turtle. Thank you. Goodnigh offered me one offline, so you can have this one. I do appreciate the thought. Merry Christmas All. Curtis

Don, I'm looking for a rear deck panel for my '73 convertible. original pn# D1ZZ-7640310-A I looked at the dynacorn site and they don't show it yet. Do you have anything ? Also see Dynacorn shows the 71-73 FB roof panel, pn 3643XL and the roof braces 3643ZF Do you have these yet or know when...

If Turtle doesn't take it I definitely will for my '73 'vert build.

What plugs did you use ? What is the gap ? What did you set the points gap to? Did you replace the distributor or the distributor cap and rotor? Are you sure the firing order is correct? If you work the accelerator, does the carb spray fuel into the engine ? If not, the carb isn't getting...

I found them thru another site in their Standard motor part numbers along with some wire diagrams. http://www.jeepsunlimited.com/forums/showthread.php?464032-Build-a-Duraspark-Wiring-harness Coil connector Standard S-583, $6.63 Amazon 3 wire connector Standard S-629 $15.54 Amazon 4 wire...

As described above, they are a window anti-rattle clip. You can plasti-dip the new one and they come out almost like original.

It could already be a rebody. Without the front fender aprons there's no telling what that chassis serial # is. That is in very ruff shape. Floorpans gone, part of the roll cage cut away and on and on...

Still looking for this. Any luck ?