Search results

I’m about reinstall my rear window in my Grande.  What are the thoughts on using the closed cell foam tape on a coup..... The window leaked a bit before I removed it. Any input will be appreciated

Car is back from paint.  Putting the front bumper back on and it was always too far out from the fender indents.  Can the bumper bracket/ absorber be adjusted?

https://comoxvalley.craigslist.org/cto/d/72-ford-mustang-2-door-sport/6787888170.html That’s around 15k usd

I am in need of a left, drivers side, roof rail for my 73 grande. Does anyone know if these are reproduced? Or know of a quality original? Thanks

Is it possible to remove my vinyl roof trim on my 73 grande without taking down the new head liner? Both vinyl to and headliner were done by PO. It about the only thing he did well so I don’t want to mess with it before a respray.

http://portland.craigslist.org/clk/cto/5878262131.html Surfing around and found this one. I would jump on it if the Canadain dollar wasn't so dam weak.

I fixed up my steering coupler "rag joint" last night. Because of the headers I think I was a little rough on the steering box. When I first tightened the steering box it was crammed in so tight against the steering shaft it started to drip fluid from the input shaft! I then loosend the...

Wondering if anyone out there has tried these rods? http://www.pacificthunderperformance.com/collections/1971-1973-mustang

I am looking for some advice on tightening up the power steering on my 73 Grande. I am about two weeks away from getting my 351c back from the slow but meticulous engine builder and I'm afraid I'm going to have a hard time keeping my girl on the road with the high performance engine. I had the...

Looking for some more advice. I have a 351 cleveland that has 2 cracked heads and a cracked crank. It is a matching block to my 73 Grande. I have a great engine builder ready to rebuild it but it is going to cost a lot....... And will but out 350+ horses. My FMX transmition is being "...

Hey guys. I bought my 73 Grande a year ago. Great southern cal car that has been a pleasure to work on. It was running a little rough when I got her, typical exhaust leaks and vacume leaks, but by the end of last summer I had her running pretty good other than a knocking noise at certain rpms...

So I was trying to tune my 351c 2v with edelbrock carb this afternoon. It was pinging a lot after a long winter. She has fresh 93 octane fuel. I set the idle mixture with the rpms at 300 then set the advance to 10 degrees. Then I set the idle with it in gear and lights on at 675rpm. I took her...

Hey love this site, I have found it so helpful. Latest problem. Just finished detailing the engine bay. Looks great, used two part flat black and looks way better than I had imagined. Problem was the power steering pump was a mess of forty some odd years of minor oil leaks spread all around...

Hi guys. Just looking for a little direction here. I had some fist size patches of paint peeling off the top of the cowl area. I couldn't stand the site of bare metal so I scraped and sanded most of the paint off. As it drops down towards the engine bay there is a seam. I chipped away what I...

My 1973 grande looks to have the stock distributor with the points removed and electronic added. My problem is that when I want to turn it clockwise to advance the distributor the vacuum diaphragm hits the rad return hose? So I can only get about 4 degrees atdc? The engine is a 351c. Was a 2...