Search results

Hello everyone - first apologies if this is in the wrong forum. Trying to button up the instrument panel, and I cannot find the yellow-white wire that oes to the fuel gauge anywhere. I seem the loom coming from the sending unit and up the side of the driver door, but not a singe wire in the loom...

hey, i cant find the fuel gauge wire behind the dash panel. i see it goes from the fuel tank then into by the wheel well, but i cant find it after that. can anyone help me to visually find it so i can follow and trace it so i can route it to the dash?

hey everyone, i have a 73 with the fold down seats. i cant figure out how to remove the back section of the fold down set to get to the rear shocks. i see the two brackets on the piano fold parts after you remove the rear seat, do i have to remove those two sections to remove the section that...

is there a kit anywhere that has all the suspension bushings for a 73 mach one? i found this one: http://www.cjponyparts.com/prothane-total-bushing-kit-without-transmission-mount-1967-1973/p/SBK12/ but that is poly and i was hoping to keep it rubber so that it wouldnt ride really hard. also...

the windows are really hard to move up and down. its manual windows and has been sitting for who knows how long. the windows are also a bit unstable and can wobble when going up and down. does anyone know how to grease the window tracks and gears and what grease to use?

what is the blue wire with a white stripe that is by the fuse box? it is taped to a ground wire that has two black wires going to a spade connector. im not sure if they are related or not. also, i had a parasitic drain on the battery, when i unplugged that blue wire with a white stripe from the...

so i have 73 mach i am restoring. i replaced all the wheel cylinders and brake components on all 4 tires. the driver front was not leaking when i bled it so i changed the rubber line and it worked fine. i bled them all with a helper on the brake pedal and it was tight and seemed to work well...

so my battery has been draining hard recently. i just saw that when my battery is on a trickle charger, the tachometer sits around 1.5k and if i take off the charger it falls back down to 0. also, on a side note, not sure if its related. but if i turn on the turn signal switch and touch the...

so i have quite a few wires behind the dash that are unplugged. i assume not all of them are going to be plugged in, but im hoping you guys could help me identify them. heres some pics: under the driver side: 1 http://i.imgur.com/nEIkmNk.jpg 2 http://i.imgur.com/8LsasmS.jpg 3...

so i have power to the engine and it runs great now. i also have power to the headlights. but thats about it i have no brake lights, no interior lamp, no gauges, no clock. any idea where to start?

ok, so i got my mustang running finally. it has a 71 351c in it. we managed to get it started today but, the timing seems be going all over. my family friend who is very knowledgeable on cars said that it was bouncing around it seems. it also kinda sounds like one cylinder isnt firing as well or...

i rebuilt a 85 T5. i followed a video guide on how to rebuild it to the letter. now i have it all installed in the car but the yoke on my driveshaft (i had it custom built, its the correct yoke) wont go far enough into the transmission to install the rear end in. it goes into the trans about 2.5...

so im trying to wire up my alternator. ive looked at pics and wiring diagrams and im not 100% sure i have my alt wired right. can you guys just take a look and see if it looks good? heres a pic: the color of the wires (as far as i can tell, they are quite dirty) are as follows yellow going...

on my 73 i was going to take off the diff cover and drain the fluid to put new fluid in. well i got the yoke off and the cover connected to the yoke, but the main cover is stuck on. i cant get it off for the life of me. my question, is it worth me banging and beating off it to try and get the...

so i got a 73, and i was hooking up the battery for the first time today. when i plugged it in the starter started to turn over. i went inside the car to make sure the key was in the off position, it was. everytime the battery connects, the starter tries to turn over. im assuming i have some...

So i found a guy that would sell me his fromt disc spindles and calipers for about 200 bucks. They are off a 73 mustang. My question is will they fit mine? I have a 73 mustang with drums in the front but i believe they are the smaller tires. Would i have to get bigger rims to fit the disc...

so i put my headers in last weekend (hooker headers) and they are just a tad close to the power steering column. i have pics to show. how much of a problem is this? what could go wrong and do i need to do anything? there is a small gap between the header and the knuckle. they arnt...

these are wires im not sure what they do. they are located in the engine bay, driver side by the fire wall. http://i.imgur.com/AAFO6vC.jpg http://i.imgur.com/mkAugFj.jpg http://i.imgur.com/t1ShMj9.jpg http://i.imgur.com/gGM9QzN.jpg except this one. its up by the battery and the solenoid...

so i got the vacuum lines for my 71 351c 2v from Scott Drake. BUT, the vacuum diagram they gave me has been copied and printed about a hundred thousand times. so i cant read the diagram at all. can someone give me a good diagram or even better, a pic of where all these vacuum lines go?

ok, so i rebuilt a 71 351 cleveland and put it in a 73 mustsang mach 1. i need help with the wiring, its definately not my strong suit! so these pics are of the wires that are currently in the engine bay by the battery tray. if you guys can help identify what they are, where they go, what im...