Search results

Does anyone have a 73 ac wire harness that is not installed yet? I’m having an issue with ac clutch wire. I don’t remember if there is a connection between the firewall and the Deicing switch. Is the c-1006 connection under the dash somewhere? It’s a black wire wire With yellow hash marks I...

Has anyone redone the leather wrap on this wheel? What did you find behind the old leather? Mine had duct tape under the old leather. I don’t know if it was the original wrap or not. What was under yours? 73 mach1 deluxe interior Sent from my iPhone using Tapatalk

I am replacing the ignition switch on my 73 with a tilt column. I’m trying to insert the new switch and the pin is retracted with the pin retracted the triangle part on the ignition is 180 out from the piece in the column. Am I doing something wrong? Sent from my iPhone using Tapatalk

I have a 73 Mach 1 with 351c FMX trans. I was thinking an overflow tank but not sure. Any ideas? Sent from my iPad using Tapatalk

Does anyone have the breakdown showing how the power steering is mounted on a 73 Mach 1 with AC? I have 3 studs that go on the ac bracket but I’m not sure if that’s what holds the power steering also. Any help or pictures would be awesome. Thanks Dennis Sent from my iPhone using Tapatalk

I have this steel double vacuum line I believe comes from the 4 port manifold on the firewall and to the soup can looking reservoir on the inner fender. I can’t figure out how to route it. Does anyone have a picture of one routed? Thanks in advance Dennis Sent from my iPad using Tapatalk

Couple of under dash wiring questions. I have a 73. Mach1 with power windows and a/c. It also has. Factory tach. I’m having trouble figuring out where a couple of wire go. The first two pictures are wired that come from both kick panels. I’m pretty sure thy have something to do with the power...

Is there a resistor between the battery and the coil on a 351 cleveland? Its been rebuilt and I’m getting ready to run it on a stand to break it in. Just don’t know if it can be straight 12 volts or if it needs a resistor. It don’t show one on the wiring diagram. Right now it’s just set up to...

Can any one tell what these wires go? The first three are from the drivers side and the last one is from the passenger side kick panel. It’s a 73 mach1 with electric windows. Sent from my iPhone using Tapatalk

I’m reinstalling the ac heater box and wiring. The wiring for the thermostatic switch ( deicing) is a green wire and a black wire with white dashes. Does it matter which terminal on the switch? The wires are circled in blue. Any help is greatly appreciated. I accidentally put this same question...

I’m reinstalling the ac heater box and wiring. The wiring for the thermostatic switch ( deicing) is a green wire and a black wire with white dashes. Does it matter which terminal on the switch? The wires are circled in blue. Any help is greatly appreciated. Sent from my iPad using Tapatalk

I built my own rotisserie and put my 73 Mach 1 on it. Now I'm trying to get the center of gravity right. Do the rotating points have to be at the same height? I can adjust the mounting points up and down obviously the front is lighter than the rear would the adjustment on the front be higher...

I'm restoring a 73 Mach 1. I went to Jim Osborn's site and they only offer the body, interior, and chassis. Electrical only goes to 72. Will the 72 manual work for the 73? Also does anyone know a good manual for the engine assembly? Sent from my iPhone using Tapatalk

Well this is my introduction I am restoring this car with a friend. It is a 351c 2 barrel original car. I'm sure I will be on here asking a lot of questions. Sent from my iPhone using Tapatalk