73pony

Today's fuel doesn't do well with sitting around for years. The cautious approach is to disconnect the fuel system at the pump and run...

Welcome from Iowa. Make sure you are not running old gas through the carb etc. It turns to varnish and will cause a lot of problems. I...

I'm at 49 vehicles that I can remember at this point (not including boats) and counting as well as 2 wives and counting. 1986 Pontiac...

If there would be enough interest in a 71-73 gathering I’d be willing to try to get something put together here in south central...

I understand completely what everyone is saying. I am part of a club here "Iowa Mustangs Unstabled" we have a lot of great events and...

Its not only happening to Mustangs but other vehicle's as well along with the Hot Rod Power Tour. We went to a show in North Carolina...

That's too bad. I guess a lot of the classic Mustangs had been to the 60th Anniversary event in Birmingham and the Boss Reunion in...

Sounds like a cool project. I will caution you on the 4.6 2V though. I had a 99 GT with the 4.6 2v, swapped PI heads and upgraded cams...

You did an excellent repair @73pony, it will be fine.

Since the section of threads was magnetic I assume it was the block.

Thank you for all the suggestions. Here is what I ended up doing. My flowkooler pump will accept a 3/8 bolt in this position. Without...

Was losing coolant. Found it was leaking from one of the water pump bolts on the lower driver side. Thought maybe the thread sealant...

A new brake pedal rubber cover…and I polished my stainless trim… Sadly, I bought this “in stock” item in May. It arrived today. Year...

I snagged a nice set from a fox body with the bolster etc for cheap. I'm in the process of cleaning them up before test fitting. I can...

Just part of the mandatory safety gear, but you may as well look good, so it's painted to match the boat. Knock on wood, I've never been...