Help Support 7173Mustangs.com:
-
-
To see what RPM you will be turning with the 3.25 rear axle gears at 60 MPH, take your current engine RPM at 60 MPH using the 3.0 gears... -
73Mach1VA replied to the thread Power steering Pulley.Is this the pulley you have? https://marchperformance.com/ford-corporate-power-steering-single-groove-v-belt-pulley-502-c.html
-
73Mach1VA replied to the thread Power steering Pulley.Yep, this Scott Drake is a pos. No groove either side. No way it will work. Original was damaged. I can get a standard pulled on it.
-
I put on a new power steering pump using the factory bracket and picked up a Scott Drake Pulley for it. The pulley doesn’t line up...
-
-
Not sure how many of us have used sockets as spacers or to seat grease seals. I do know that few admit to doing it.
-
73Mach1VA posted the thread Transmission C6 Linkage-Control Assembly help. in Engine, Transmission, Drive Line, Etc.I have a 73 Mach 1 Q code with the C6 transmission. A previous owner has done some "interesting" things to this car. I have attached...
-
-
73Mach1VA replied to the thread Removing oil pan.Got the oil pan off. Thanks for the help. Had to lift the motor on the Cleveland. Didn’t have wood handy so used a couple of sockets...
-
-
The typical process is: Remove two fan shroud bolts, unclip from bottom of radiator, lay back on the engine Remove motor mount through...
-
73Mach1VA replied to the thread Removing oil pan.The “while I’m here” is how I ended up where I’m already at. Which led to the oil pan. Lol All started with a leaky power steering pump.
-
-
I have a 351C, can I remove the oil pain to replace the seals without removing the entire engine?
-
73Mach1VA replied to the thread Frustration with Front end!.Thanks. Ironically, those are some of the exact items I ordered already. Let the fun begin!
-
73Mach1VA replied to the thread 73 Gas tank vent.Great info. Thanks. Some previous owner stripped pretty much everything that they deemed non-essential. I think they were all about...
-
-
73Mach1VA replied to the thread Hole in rear end.Interesting. I bet that's what it is. It was definitely set up as a go fast at some point.
-
73Mach1VA replied to the thread Frustration with Front end!.Thanks for all the input. I have decided to replace pretty much everything. If I'm going to take it apart might as well only do it once.
-
73Mach1VA replied to the thread Hole in rear end.It's just a bolt. A fairly long one at that. It does have a fill hole. I plan on breaking it all down and checking everything...
-
-
Loading…
-
Loading…
