RIBS

My $160 Grant wheel is Big, like stock, works fine. In 3 years I had one incident where the horn wanted to beep on its own. A small...

This part in some way supports the quarter window, I am not sure how…when I disassembled I only had one, and also lost track of how to...

The seat frames and mechanisms have value, they are fairly easily recovered, so you shouldn’t feel bad about asking for $. Very generous...

I built a paint booth out of 2x4, and old wedding tent and a big roll of plastic, got 16 $12 LED lights, bought a compressor for $1600...

It’s a plastic panel support. It should fit up under the edge Of the interior panel…

I have a repro from NPD, they are known for searching out the best of everything…when my body shop guy put it on, it dimpled in at the...

Seriously, do it!

I painted mine myself. $4500. Waiting that long is insane.

I have the full system minus condenser and a few bits outside Atlanta, but it would be a pain to ship. If you find yourself short...

You are indeed looking for the most expensive and hard to find part…there is a guy making repros somewhere, not sure if he is doing...

Can you be more specific about what you are looking for? Most is available as quality used or reproduction parts…

It really boils down to what sound you want. Slight rasp with X, slight rumble with H. The performance gains of each are so minor it...

A wave of salt water over your truck and down your intake pretty much spells death. Even if your engine was replace, all your electrical...

My 4 barrel Edelbrock carb required about a 2 inch extension…, and yes you need a forward spring, the forward position is normal driving…

I've never had good luck with that. Its easier to just buy 5 different belts in half inch increments. Then return the 4 you don't...