GERMYS_72

Bill, I haven't pulled the trigger yet. Feel free to message me the details, I'm interested.

Yes , I bought a 1972 stock pedal assembly from Colorado Mustang awhile back. Thanks for the offer, I'll keep that in mind if I run into...

Thank you dawson for the response from me resurrecting your 2 year old unanswered thread. lol I will see if I can find a cheap...

You can use that yoke with a 1330/1310 conversion u-joint. Factory front u-joint is a 1310. The conversion joint is Spicer 5-134X.

This yolk on NPD uses bigger U joint (1330), is that too big for the factory driveshaft ...

Unsure the quality but I found this. https://secure.cougarpartscatalog.com/d2zz-4841-a.html You might try summit racing if you have...

Yes, that's what I intend to do. I just want to make sure and get the right carb the first try, I don't want to be troubleshooting...

Thanks for the suggestion. since I will drive very few miles , I want to stick with old school carb.

I do suggest you not to use a Carb. Go EFI, it´s much better on every day use.

What yoke did you end up using ? I'm doing the same exact thing FMX to toploader

Roland, I have 351C 4V - 70 Mustang M-Code engine and intake, and caught this post. Can you say why Street Demon as opposed to a Holley ?

Take an original stock 351C Intake from a 70 Mustang M-Code, and put a 625cfm Street Demon on it, and not forget, install a Pertronix...

Great feedback Hemikiller, I will look out for a stock 28 spline yolk. that small difference of driveshaft length won't be a big deal...

1 - you can run whatever air cleaner you want 2- The factory 351/FMX driveshaft is 51 3/32" ctr to ctr of the u-joints, the one for the...

1. I'm putting a 351C 4V D0AE engine from a 70 Mach 1, into a 1972 fastback. Should I be using the 1971-73 "Q" code air cleaner ...