Recent content by darrylmach1

73 h code mach 1

I know this engne doesn't fit our 1971/73 site, but i thought it was an interesting engine someone might need. block #'S doze-6015a head #'S doze6090a http://boise.craigslist.org/pts/2990932281.html

Any prices on these items?

If you have a multimeter try this or you could swap coils. Check the ignition coil primary coil resistance by connecting an ohmmeter between the positive (Black wire) and negative (Green wire) terminals on the coil. The resistance should be 0.4 to 0.6 ohms. Check the ignition coil secondary...

::welcome:: I'll bet i don't live more than ten miles from you. Nice project good luck!!! Darryl

Thanks very much. Just what i needed

Am hoping some member can help me out. I'm looking for a complete rear window defrost switch assy. (switch, relay etc.) for my 1973 Mach 1. Have a rear window with the heat lines but that's all i have. Also looking for a pair of 1973 351C motor mounts. I can locate plenty of 1971/72 mounts...

::welcome:: Welcome from Boise, Idaho area

I think i'd go with a 1-1/8", i might try it myself.

Jeff, The ride is quite firm, but not harsh, 5 leaf mid eye rear springs, i can't remember if the stock front sway bar is 13/16 or 7/8, but the 1" made a big difference. I'm sure 1 1/8 would make a difference also. the rear sway was a kit from mustangsplus.com. Right now i'm just using...

Thanks to all for a warm welcome. I'm posting a description of some of the things i've done to my mach. Also listed is how i achieved the stance i wanted The previous owner said he didn't want to see it again it would be too painfull. I've tried to post more pics but were too large to load...

Hi, My name is Darryl, live near Boise, Idaho. My mustang is a 1973 mach 1. I bought it in 1999, took me 10 yrs to convince the owner to sell it to me. I've done a lot of mods to the engine, transmission and rear end and suspension. the exterior and interior look very good and haven't had...