Don C's latest activity

7173Mustangs.com

Help Support 7173Mustangs.com:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  • Don C
    Don C replied to the thread Ghost In the Machine.
    Unfortunately, new does not mean good. The ignition circuit has a built-in resistor. The portion of the wire that runs from the...
  • Don C
    Don C replied to the thread Positive Coil Circuit Power Rating.
    The stock coil with the 1.4 ohm resistor wire and 1.4 ohm primary resistance coil draws about 4.3 amps with the engine not running...
  • Don C
    Don C replied to the thread Part location?.
    It's a brace that goes from the bottom of the front fender to the radiator core support. It's shown in the Body Assembly Manual, N-105...
  • Don C
    Don C replied to the thread When you're hot, you're hot......
    It is hot with the ignition in run or accessory. Midlife also has them http://midlifeharness.com/products.html
  • Don C
    Don C replied to the thread The Gremlin is Loose.
    The only circuit that is common to all of your gremlins is the ground circuit. I would start there, making sure your battery is properly...
  • Don C
    Don C replied to the thread Hood scoop insert screws?.
    The reference number is FF162
  • Don C
    Don C replied to the thread Hood scoop insert screws?.
    bkdunha posted a thread several years ago with the hardware listings https://7173mustangs.com/threads/71-73-hardware-information.23685/...
  • Don C
    Don C replied to the thread Speedo cable issues.
    You may be pushing the clip in the wrong place. Where you need to push it in is as close to the speedometer that you can. The notch that...
  • Don C
    Don C replied to the thread Duraspark II with ram air debacle.
    When the engine is running the voltage varies depending on if the points are closed or open, or in the case of an electronic ignition if...
  • Don C
    The plug to the tachometer will have a re with light green stripe wire on both sides of the plug. You might want to download the wiring...
  • Don C
    I came across this today, a paint that is supposed to look like dichromate plating. Yellow dichromate plating is somewhat of a...
  • Don C
    Don C replied to the thread Rear main seal on 1969 351 windsor.
    The procedure for replacing it with the crankshaft in the engine is given in the Ford Shop Manual, volume 2, page 21-21-20. You can get...
  • Don C
    The diagrams in post #5 of this thread should help you: https://7173mustangs.com/threads/alternator-and-regulator-wiring.40107/#post-409306
  • Don C
    Don C replied to the thread Issue with rocker arms.
    For a 351C the rocker arm to cylinder head fulcrum bolts should be torqued to 18-25 ft.lbs. 5 ft.lbs. is what the rocker arm cover...
  • Don C
    Don C replied to the thread Strange noise.
    One of the main causes of a differential seal leak is a problem in the differential, usually the pinion bearing going out or loose.
Back
Top