Don C's latest activity

Those cracks show that delamination has started, you need to probe them with a small flat blade screwdriver to determine the extent. In...

We need to see the rubber that is between the two metal pieces. What you are showing on the surface has no effect on the motor mount...

The rubber that you have to worry about is between the two brackets. You'll need to inspect it for deterioration and delamination. The...

Get a 4-point 3/8" socket. You may have to buy a whole set of drain plug sockets to just get that one socket. Or, weld a couple of 3/8...

HBA-CF isn't shown in my parts catalog, nor StangerSite's pump decoder: https://www.stangerssite.com/FP_IDchart.html nor the...

Several members have replaced the original gauges with new aftermarket gauges. Search the forum for 'new gauges', here's an example of...

https://7173mustangs.com/threads/my-dash-center-section.34419/

The picture is of the headlight switch angle adapter, adapts the line of the switch to the angle of the back of the dash. You should...

I got one from NAPA several years ago. https://www.napaonline.com/en/shop/replacement-parts/brakes/brake-boosters/325626278

Unfortunately, new does not mean good. The ignition circuit has a built-in resistor. The portion of the wire that runs from the...

The stock coil with the 1.4 ohm resistor wire and 1.4 ohm primary resistance coil draws about 4.3 amps with the engine not running...

It's a brace that goes from the bottom of the front fender to the radiator core support. It's shown in the Body Assembly Manual, N-105...

It is hot with the ignition in run or accessory. Midlife also has them http://midlifeharness.com/products.html

The only circuit that is common to all of your gremlins is the ground circuit. I would start there, making sure your battery is properly...

The reference number is FF162