Recent content by GB 71

Thanks Guys

71 Mach 1 tail light harness connectors black and white located near both turn signal lamp wiring?  Thanks

Hello all! Can anyone identify this harness?

Hi everyone, On holiday here in the UK, I though I would send a pick of my rental...it's a Renault Captive with an impressive 89bhp, 162lb ft, 1.5 lithe, getting about 80mpg, Diesel is running 1.19 per liter so I am glad I got a diesel. Thanks George

Thanks for the fast replies and I have to say that this site is without a doubt the most informative with all aspects of 71-73 stands. I could have never been where I am on my restoration without this site. I certainly learn something new everyday that I browse the postings from present to...

Hi, I have a 71 fastback with a Rug AV1 toploader and for the past year I have been working on anything and everything but the trans. It's just about ready for paint and Today I decided to change the gear oil and at first only about a quart or so came out and I don't know the history of the...

Hi everyone, 71' here I was doing some body work and came across holes in the bottom of the quarters and bottom of the front fenders towards the rear. Looks like 5 or 6 mm holes about 5 inches from the bottom of the panels.? Is this for lower trim moldings? Any help would be appreciated...

Thanks guys....I know what I need to do...

Hi guys I need some help identifying which goes Where? For my '71 , Per the pic below... From what I can assume is that "A" bolts near the doors, "B" are for the back seat, "C" mounts on each side of the center console. And "D" is ? I think it's a shoulder strap, and I assume there should be...

I'm just north of Philly and if your looking for some help with these let me know George ::thumb::

Hi guys, Does anyone know where to get a pair of seat hinge bolts for a 71 highback Seat? Can't seem to find them anywhere.

Thanks guys, I did find a tag covered in undercoating of some sort and it's exactly as you've said. 70/71 top loader 28 spline wide ratio....

Hi guys, Looking to identify my transmission. See pics. Transmissions are my weak point. Any help is appreciated. There is no tag. Just a stamp near the drive shaft end. Looks like 7A0AO? Need to change the gear oil as well. What brand/ type is recommended? Thanks in advance George

71 M code - 4 speed - Standard Interior

Good Afternoon, I have a question regarding the orientation of the front crank seal. The engine is a 351 Cleveland 2V. Does it install from the backside of the timing chain cover? and can this be installed without a press? Thanks in advance George