I'm totally jealous! Nice Mosin - I have three that I bought / restored (One for me and each of my boys). Performed trigger mods on all three and they all have a nice, clean break at 6 lbs. Don't know if you re-load or not, but I have some good 7.65x54R "recipes" I could share.
Best ,
Dwighht
Thought I'd post a couple pictures of my daughter's car I've been working on...It certainly helps to browse this site for tech info and inspiration!
All the best,
Dwight
I’m interested in the group’s opinion/troubleshooting approach on what’s going on w/ my car. Problem description as follows:
1971 Mustang Coupe – Ford 302 w/ Autolite 2100 carb. Finally got the car running and was taking it for a test drive around the block yesterday. When I gently roll on...
Dumb question, but wondered what ya'll thought...
I finally got the car running and after a couple laps around the block, I noticed anti freeze dripping at or about the firewall on the passenger side of the car. Later that night I pulled the passenger seat (to start removing carpet) and...
Glad too see all the input about this topic. I have the same issue w/ the car I just bought and as some have mentioned, I thought the previous owner installed big block springs. I bought some coil compressors yesterday and at some point during the restoration, I'll use the advice here to lower...
Hello to all:
I'm a new member and 71 mustang owner. The car was purchased for a "father / daughter" project, which is just getting underway.
Looking forward to talking w/ everyone.
D.