Thanks for update. It was frightening how easy that joint came apart. Would have failed at any moment... really glad I looked into it.
Sent from my iPhone using Tapatalk
I have the Dorman kit to rebuild, I was just curious because there are no guide pins extruding from either side of rag joint like on many pics I have seen. The rivets are flush on both forged sides of joint.
Good advice on grade 8 bolts.
Thanks!
Jeff
Sent from my iPhone using Tapatalk
Hey Crew,
I pulled the column and rag joint because getting Ready to do floor pans and easier with it out of the way. Also, old brake master cylinder leaked and turned rag joint to mush.
In my research prior to yanking it, I had a good idea what to expect. As you can see in the pics, my column...
Pulled heads and sent them off for checking and head job. The valve guide and stems were in really quite rough shape. Will start dissembling the bottom half this week.
Sent from my iPhone using Tapatalk
Thanks for the reminder on head bolts. Would you mind looking at the pics I posted earlier and adding any analysis. I just haven’t had that many engines apart to really gauge what is going on.
Sent from my iPhone using Tapatalk
Update! Got her out and had great help from my kiddo.
Wasn’t difficult at all, wished I would have just pulled her two months ago instead of farting around trying to diagnose. Lots of grime on that side of engine, failed oil pan gasket perhaps? The driver side is equally worse but I had a PS...
Yeah. F these bolts. I am going to just yank the motor. I will spend more time jacking around and skinning my knuckles than it takes to pull her.
That pushrod on 4 cylinder was full of goo, no oil could go up it. I will plan on sending heads out for valve work once I pull her and check out the...
Ok, dumb question. The exhaust manifold bolts are a pain. I can just just pull the head out with exhaust manifold still attached right?
Sent from my iPhone using Tapatalk
Some pics of after I pulled the intake. Kinda gross, the intake manifold gasket was a turkey pan style and hard to tell but I am fairly confident there were some areas that were leaking vacuum.
Some strange particulate in valley, almost charred looking oil?
Most concerning was # 4 cylinder...
Update. Decided to go ahead and start pulling the heads and see what it going on. When I drained coolant, noticed some oil in with coolant. Got intake almost ready to pull... Really not looking forward to exhaust manifold bolts. Got everything soaking overnight in PB blaster, for what that is...
Did Dons technique and air was coming out through the exhaust(tailpipe) as well as through the breather hose in back of passenger size valve cover. Thoughts???
Around 90 percent certain I had #3 at TDC, that was a little tougher than dialing in #1. Lol
But back to my original post, would this...