Search results

Thanks. I purchased a 72 shop manual and it has the same drawing you forwarded. I have seen some posts where the rear measurement was corrected to 15.03. Do you know what is the correct one? Thank-you

thanks, I will give that a try. much appreciated

Hi All, I am fitting a new Dynacorn front end with new fire wall and cowls. Horizontal alignment was relatively easy and matched the attached drawing. I am struggling with the vertical measurements matching the drawing and have come to a stand still. I am working off of a level 4 post hoist...

I had my car painted several years ago and the outside is solid. It has a 390GT engine and I finally decided to move forward with a 5 speed Tremec upgrade and a full floor replacement. After I removed the existing floor pan the job quickly expanded to include the entire underbody. I have...

Awesome, much appreciated. This is my first restoration project and I prefer to measure twice and cut once lol. It makes sense now. Thanks from Canada

I clamped new rear torque boxes in place as per measurements taken prior to removal. I was hoping to verify as per the attached drawing I found on the site but was scratching my head at the horizontal measurements (the vertical ones are straight forward). The torque boxes match the drawing if I...

Thanks for the info, much appreciated

I clamped new rear torque boxes in place as per measurements taken prior to removal. I was hoping to verify as per the attached drawing I found on the site but was scratching my head at the horizontal measurements (the vertical ones are straight forward). The torque boxes match the drawing if...

Thanks much appreciated. I was able to get the last one in stock at NPD NC. The original is in poor condition (I live in Canada so the car did see salt in its early years). Thanks again

Has anyone replaced an entire firewall assembly? I am installing a full floor panel but the rust continues up onto the firewall. Couldn't find toe boards and the only firewall panel that i could find for non ac was for a convertible. I inquired at NPD to see if it was only slight modification...

Purchased new frames/torque boxes from National Parts Depot and they match the originals. I have removed both frames but took a lot of measurements. The rear cross member is still in tact so i have a reference for the rear of frame for height. I did a dry fit and all pieces align very well...

I am new to the site. I found underbody dimensions on the site and when installing rear frame/torque boxes I found the rear spring rear hanger hole measurement approx 1 1/2 inches different form the original. The rest of the measurements matched the car pre disassembly. The drawing showed...