Search results

NO a lot available. I have a thread on it somewhere. But you arer kind locked into two sizes

thats really bad..................................

Some trim is good. The windhield molding and the drip rails is fine

Make sure you rebuild the door hinges and line up the doors and fenders before you do the floors!!!!!!!!!!!!!!!!!!!!!!!

I would butt weld it. That's the best way.

After you strip the roof down. Buy a gallon of 911 rust remover. It is a concentrate and will make 16 gallons. Wet paper towels with the 911 (after you dilute it). Once wet put on rusted ares and cover with saran wrap. This will keep the area wet. After about 24 hours the rust should be...

Coming along nicely

A light and I mean light bead blasting followed by SEM is a good way to go

Looks like $3G tops...........

A lot of work! Good luck. I hope you persevere!!!

That'a the other thing is it worth the extra cash for the 600HP unit. I don't think the 351 will ever hit the 400 mark . It is stock

I'm thinking of buying one.  I kinda think I should buy the 600HP version.  Leaves room for growth.  The car probably makes 250HP right now LOL.  Anyway, I have been reading about the fuel choices 1. Fitech command center (has a slew of problems that may or may not be fixed) 2. RobbMC surge...

Before you blame your friend you should look internally. If the cam is wiped it is not his fault

The issues is that car backfired 3 times with flamage through the top of carb in getting her started. THis happens I again, turned the idle/air screws all the way in and then out 1 1/2 turns. I also adjusted the hot air choke a little bit. Sounds good Car started and ran for 30 seconds or so...

POR 15 ticks o rust. If you remove the rust it does not stick . I would use epoxy primer

The plastic piece is pushed into the clip. I would gently try to pull it out if you need use some heat. A heat gun softens the plastic or a hair dryer

I have four jack stands! Big sheets of cardboard are easier to lay on than a creeper. Lots of light. It just stinks!

The funny thing is I painted mine anyway. My wives car is not original and the painted finish looks great. The car is in my build thread.

MY NOS grill was no shiny at all.............

Not my cup of tea but very nice