Search results

Looking for a decent, clean pair of white(or off-white) 71-73 Mustang sun Visors. With or without the mounting rods. Mounting rods/brackets would need to have nice chrome.

Looking for good, old OEM brake hardware that can be cleaned-up and reused. Need a pair of parking brake cable levers(R &L) and a pair of parking brake link bars as shown below. Must fit the 10 inch brake drum from a 351C Mustang or similar Ford car. Thank you ! JPW

I have observed these two different inner tie-rods beings used on our cars. Can anyone tell me which may be the Ford OEM tie-rod and which may be a replacement item? Or perhaps Ford used both these styles over the years? Thanks in advance! JPW

While looking for the captured-style engine mounts for my 1973 351C Fastback, I came across these 1973 Torino / Ranchero / Failane engine mounts that appear to be very similar to the 1973 Mustang's. Can anyone comment on whether they will interchange? Thank you in advance. JW

Looking for a very good condition, not-too-faded avocado deluxe door carpet. Passenger side only (but will buy both RH & LH). With or without the speaker cut-out is OK. If you have an otherwise non-usable, avocado deluxe door panel that has nice carpet, let me know! Thank you in advance....

I have the correct 73' frame brackets - Looking for two of the original captured style. Detroit area.

One pair of new, unused RetroBelt®'s 3-point lap and shoulder belt kit. Never installed. Includes everything you will need to add a retractable belt system for two front seat passengers to your 1965-73 Ford Mustang. The 12-inch plastic sleeve makes this system perfect for installation in...

Could someone confirm whether or not a front fender extension seal is used? I do not see an application for the die-cast front extensions like the rear quarter extensions. Also --- if no traditional rubber seal was used, does anyone have a nifty way to keep the joint from cracking paint? Thank...

Just finishing up the final touches on a 351C (M code converted to 4bbl) rebuild in a 1973 Mustang. The engine started nicely and I have run it in for 30 minutes or so. When I went to adjust the initial timing(vacuum line disconnected and plugged), the distributor vacuum pot is hitting the top...

Hello Colleagues.     I would like to detail the drive shaft on my 1973 Mach 1. It came from the factory with the 351C 2V/C6 power-train and a 2.75 rear gear.  I do not have the build-sheet for the car. I would like to add the color code stripes to the driveshaft. I have determined the...

Hello Members,     Just wondering if any of you know of the feasibility of retrofitting the OEM 71-73 Mustang power steering gear boxes into the 69-70 Mustang? I am looking to get rid of the loose and leaking system on my 69 Mustang.  Thanks! :huh:

Looking for a very good 71-72 passenger fender for light restoration. Must be OEM. No junk or aftermarket items, please. I am in the Detroit area. Thanks! JW