Search results

I know it's not a Mustang but the plate on my 68 Camaro SS RS.

Welcome from Ontario Canada. Love the Grande!

Have the front flex hoses been changed.

I replaced my brake lines in 2021 could not find pre made because of Covid. I tried my best and got them close but not perfect. I have done lots of brake lines in my life time, it wasn't hard except the tunnel mainly because I can't bend my neck. I would suggest to buy the pre made ones it will...

Welcome from Southern Ontario! Love the colour of your Grand Torino just pops. My brother has a 72 Grand Torino Q code 4 speed with air not nice like yours all original paint faded and worn through in spots same colour as the Grand Torino in the movie. I keep telling him to take it to car shows...

It could be leaking out the back of the master cylinder. The weirdest one I ever had was leaking through the casting of the master cylinder it was so porous. I just had to change the master cylinders on my 2 Oldsmobiles they were leaking out the back. I know their GM and that's why.

Welcome from Southern Ontario. Beautiful car! Enjoy your ride.

I had my 74 Oldsmobile convertible sprayed with it in 1987 and had the car for 22 years after that and still look good.

Spray some water on the belts if it goes away it's the belts

Great find! Looks a lot like mine which was a garage find sitting for 41 years. Just take your time and massage it back to life. I soaked the cylinders with transmission fluid and left it for a few weeks before before turning it over but mine was stuck. Have fun bringing it back to life!

I finally got around to fixing the power windows on both sides. It had been too hot so waited till it was cooler. I ended up removing the regulators and putting new gear units in the motors and also cleaned up the window felts and weather stripping then put silicone lube on them they work great...

There is a Mustang parts car for sale on kijiji ad id 1698934168 for $600 in Thunder Bay

Might still have some air in the system.

Get a sheet of 80 grit sandpaper on a flat surface and sand down the pads. Takes a bit of time but works I've done it before.

Thanks Steve for the pictures looks straight forward I'm going to tackle it next week.

Thanks for all the help. You guys are great. I'm going to try removing the regulator but I have big arm and don't know if that will work. I'll let you know how it goes. Thanks again!

Does anyone have the template where to drill the holes to remove the bolt for power window motors drivers and passenger doors. I have to replace the gears inside the motors.

Have you changed the rear flex hose? I ran into that problem and it was the rear flex hose.

Welcome from Southern Ontario. What a beauty! Nothing like a ride in a convertible on a warm summer evening enjoy!

Welcome from Southern Ontario. You have a really nice looking convertible enjoy!