Recommeneded Machine shops near Charlotte, NC?

[scgamecock]

I am leery of some of the machine shops I used back when I built my 454. 1 guy really screwed up a sleeve which the cylinder leaked around the head gasket almost immediately. The next shop kept the motor for 2 months. When I put it in the guy forgot to put in one of the pan rail galley plugs!!!! That was a freakin mess. Even after the second machining I never could get the car to run cooler than 250 and that was with no traffic!!!

I am in Clover, SC just south of Charlotte, NC. Any advice on who to use that would know fords and do a good job on the block and heads?

Thanks

Wade

 

[barnett468]

call the shop below and ask for monroe and tell him mustang mike suggested you call . he should know a few, plus he does service and sells mustang parts.

http://mustangshopofconcord.com/