Don C

The ATC blade fuses aren't available in 14-amp sizes. The conversion kit from NPD comes with 4-amp ATC fuses...

You could take one of these and cut off the center piece, cut the crossover section off your EGR connector and braze it to the new...

You didn't say anything about the valves. Do not use the stock multi-groove valves. They are two-piece and the heads are prone to coming...

Cold weather effects connectors, causing them to shrink, and causes old lubricant in switches to congeal preventing the contacts from...

The resistance of the coil and resistor wire only comes into effect when the points are closed; with them open, there's no current draw...

The full width coil covers with no engine cover. The coil covers are available in blue or black...

The voltage at the battery will drop while the engine is cranking, a couple of volts is normal. So, if the battery is fully charged...

Energy Suspension now has a variety of ball joint boots: https://www.energysuspensionparts.com/universal-dust-boots.asp

Flip them over and then take the measurements of the part that actually inserts into the panel. From your photos it looks like most of...

65-70 ohms sounds right for the resistance across the coil part of the electromagnetic switch (from the purple/yellow hash wire...

The center connector should be the 12-volt input to the relay from the circuit breaker, via the black/yellow dot wire and will not show...

The formula for calculating the drag coefficient is straight forward. However, the frontal area is required. Other things that are...

I can't get to them, either. My suggestion is to assemble all of the pictures and descriptions into an article then print them into a...

Something else to check, I've seen camshaft bearings pit from condensation in engines that have sat for a while, both in and out of the car.

It was common in this era for the only separation between the trunk and inside of the car was the back seat. In standard rear seat cars...