Help Support 7173Mustangs.com:
Cribbs74
Well-known member
- Joined
- Last seen
- Messages
- 96
- Reaction score
- 31
Latest activity Postings About
-
-
Cribbs74 replied to the thread Carb problem frustration level 10/10.I wouldn’t think so it’s a rubber diaphragm. It could only get weaker or fail completely. -
Cribbs74 replied to the thread Replacement carb options.The first carb I tried was the holley 1850 and as you mentioned I would have to clearance the air cleaner to clear the fuel inlet. I...
-
For those who have been following my autolite 4100 saga I have decided to go another route. It is really important to me to be able to...
-
Cribbs74 replied to the thread Carb problem frustration level 10/10.Thanks for the reply, I think you may have missed a post or two. The one thing I didn’t bring up that you mentioned was the fuel filter...
-
Cribbs74 replied to the thread Carb problem frustration level 10/10.fuel pump was a Delphi unit. The pump that is currently on there I have no idea
-
Cribbs74 replied to the thread Carb problem frustration level 10/10.I spoke too soon. now I am having the opposite problem. Not enough fuel from the idle circuit. I went through the carb 3 times today and...
-
Cribbs74 replied to the thread Carb problem frustration level 10/10.Update on the problem. It was indeed the fuel pump. I installed the old original last night and it ran. Poorly, but no more flooding...
-
Cribbs74 replied to the thread Carb problem frustration level 10/10.Ok, back home, pressure gauge showed right at 7PSI. Now I know it was said previously that 7 PSI is marginal and anything over 7.5 needs...
-
Cribbs74 replied to the thread Carb problem frustration level 10/10.So, quick update, I lowered the floats to .491 dry and .880 wet or roughly therabouts. I also completely disassembled soaked and then...
-
Cribbs74 replied to the thread Carb problem frustration level 10/10.Floats are working well. No leaks or fuel inside. My carb is C4SE-B supposedly off of a 64 Tbird. It is 1.12, but Installed the brass...
-
Cribbs74 replied to the thread Carb problem frustration level 10/10.I didn’t explain very well. This isn’t a dirty carb issue or a non rebuild issue. I was being serious that I have pulled and...
-
Cribbs74 replied to the thread Carb problem frustration level 10/10.I dipped/ cleaned and installed a kit before I even put it on the car. The swapped Venturi’s are because I put it back together the same...
-
Cribbs74 posted the thread Carb problem frustration level 10/10 in Engine, Transmission, Drive Line, Etc.I hope I can encapsulate everything that is going on. (Autolite 4100) First start of the car and it ran and idled. Then it revved up and...
-
Cribbs74 replied to the thread Electrinic Ignition options.My distributor is a Motorcraft. Looks to be a later replacement as it has only one port on the vacuum diaphragm. As an aside I went...
-
Cribbs74 replied to the thread Electrinic Ignition options.I’ve checked primary and secondary coil resistance.Verified my inline resistor is the correct ohms value cleaned all connections Triple...
-
-
Loading…
-
Loading…