Recent content by DamageLn

LoL I wouldn't expect ya to :) I can bribe a buddy to get on it for me

Tampa, FL.

All the above! Probably some gloves and sleeves I would imagine? I'm really looking forward to this, I was hoping to go along the lines of Saturday Morning Garage but I don't really have anyone to help me film while doing repairs, so most likely any video will be of *before* and *afters* but...

Thanks for the info! I have a Northern Tool roughly 30 minutes away, that would work out wonderfully! Yeah it's a lot of work but the upside is, it's what I do for a living, the down.... Hard to do when you leave work and come home to do more :) I hated cutting the quarter panel off but the...

Those of you who do your own blasting what do you use when blasting? I have a decent size blaster and will be blasting out some inner structure and rails while they are exposed in the next couple of weeks and coating it with Rust Bullet. Then buttoning up the rear before proceeding forward with...

Hey Don, I haven't been on here in a while or worked on my car... But this interests me quite a bit! Do these quarters have the piece that welds in at the package tray?

I hesitated... Believe me! But I feel good about it now, and need to look into blasting the inner stuff there.

I cut my drivers side quarter panel off today and the inner structure is in a lot better shape than I suspected! Melted the lead out Cut out

@Qcode351mach - The car is completely gutted. No glass, no interior, wiring, or anything. The rear body and filler panels are out as is the trunk floor. I'm more worried about the 2 panels sandwiched over the quarter at the roof. The roof doesn't seem to be the problem but the inner quarter is...

As the subject says... I am replacing my quarter panel with one I recently purchased. However there has been interest with the one on my car. Is there any hope of cutting this thing off at the roof joint etc without mangling it beyond hope? The one I cut was easy as it wasn't attached to a...

Hey 73vertproject! Thank you! I picked up a used cowl section honestly like 6 years ago and its sat in my garage for a loooong time.

Drilled apart a used cowl section and addressed some issues with it. I didn't photograph the other pieces yet but I have a ton of stuff I need to get blasted, and will be going from there!

Welcome from Tampa Bay FL! I'm loving the modern dash/cockpit!

This entire post has been very informative for me, so thank you to all involved! I am at the point where I am ready to blast the majority of my car and parts and am looking into what epoxy I wanted to use. I can get DP40 readily local so this is one option as well. Have you guys had any...

I cleaned around my car today as the past couple weeks around house projects lead to some things being stored around her. Now hopefully I can get back on track