delawarebill

i've used pertronix twice. last stang i recall using the basic one and didn't make any changes to the voltage using the resistor wire...

yrs ago i also used rackerm's info. but my other '73 was a 302 engine. i found what i needed and replaced the upper/lower mounts with...

welcome from delaware.. and enjoy that special ride

the big problem i see it removing the old u don't like and replacing it with a correct one it the MOUNTNG holes. if same do it.... if...

KC u did a fantastic job. well done

welcome from delaware.

damn you guys are good.. thank you

the finger ring on trans dipstick broke off and want to replace it. the number on mine is D3ZP-7A020-AA, google it and says it's for a...

check the dates on the front tires. mine steered to the right and did the alin and tech found a bad tire. cked the dates and all were 25...

welcome from delaware.

don't forget a new front end alinment.

took the stang to a local shop that does classic stuff. did a full front suspension kit and shocks then to local ford dealer for...

Autolite Copper #24 at stock gap of .035 is exactly what i used and gapped on my 351C. the only problem i had was install. can't see...

i had the same issue with the red 73 finding the mounts without throwing my wallet away... Sooo i changed up and went totally '71,'72...

i inquired to a seller on ebay of the size cooling tubes.... this is what was his reply's were : New message from: ebf-34 (108)...