giantpune

I have a C4 sitting behind a 351. They'll do fine there for a cruiser. I'm not sure about your expectations of doing a 80mph road...

Since you have it up in the air, you can easily spin a tire and count how many times the driveshaft spins over for 1 rotation of the...

C6 transmission, pulled out of my 73 mustang. Odometer had 43k miles, and the engine still had the nylon timing set. So I believe this...

About the only way to do these cars and not spend 3x what they're worth is to do the work yourself. Whatever the bill was to do the...

Draw the same picture again, but leave out the rubber strip. Its just glass, adhesive, car frame. There is a little channel left like...

In modern cars, since like 50 years ago, that black strip comes from a tube. It is black urethane. It squeezes out of the tube via a...

I was mistaken. When I went back and looked, mine are 14".

I couldn't tell you. It checks the correct boxes for balance and tooth count. I have seen posts from folks saying that the C6 and E40D...

Regarding the flexplate, I've come across a few different part numbers online that people have successfully used. E0AZ-6375-A - Ford...

Thats the same part as the block separator plate i mentioned above. The original one from our cars have the correct holes and starter...

Yes, the old small block fords used a 28oz balance, 164 tooth flexplate. The block separator plate and the flexplate from a 70s...

What condition are you looking for? And are you trying to have them shipped or go pick them up? I have a set down here in GA that are...

I don't think that chart covers everything. There are different length 4R70W tailshaft housings and output shafts. I got my donor...

For a dipstick, I looked at a few different cars at the junk yard. The shortest one I saw was in the 4.6L crown vics and all their...

Also worth noting that you don't want to make the input and output parallel while the car is stationary. When you are actually driving...