KSpence

Been out of town, but I'm home again so I'll get my setup detailed here and do some samples. It's pretty simple and honestly, pretty...

I just started doing some zinc plating. It's been covered a bit before by some folks, but not sure if anyone's done a full end-to-end...

Vinegar, with some salt added. Use 2 zinc plates, one on +, one on -, and get the bath full of zinc ions floating in the solution...

Shock tower tops ... replated. Only did the passenger side, so showing driver's side too so you see what I was starting with

Zinc Plating in progress Did my first few items and I like how they turned out. Distributor hold down and shock tower nuts ... easier...

I got mine installed this morning. It was pretty painless. I just did the main 4 wires to install. There's still 2 leftover for the...

Zinc Plating Well I've been working on a few items in/around the engine bay and lots of the bolts were mis-painted or had some surface...

Heard from Joe @ Carb Cheater Got in touch with Joe, and here's the email I sent asking if we should over-richen the mix, and his reply...

Most young men have the attention span of a two year old. Even if he did train them they would forget everything learned in two weeks...

I read a similar question on their Facebook page. They suggested running on your normal setup before doing anything, then looking at the...

Check this out. Jet/ set your carb a little fat and let this system tune it for you / compensate for elevation. The “carb cheater” it...

Saw the videos and I just wrote them to ask a few questions. Really interesting technology, and the cool part is it only an add-on. It...

Distributor ... and now the oil pan Bought a Pertronix kit, so I wanted to clean out the distributor guts and learned tons about the...

if you suspect a vac leak, there is the old school way of using a spray, like carb cleaner, and lightly spraying the edges of the...

OK Thank you everybody... so far! It's always hard on the initial post to include all the info. To much writing... Initial timing is at...