Help Support 7173Mustangs.com:
-
-
M8-32 X 5/8
-
Mmachattack reacted to Motorcity Mustang's post in the thread Parts Wanted 1971 - 73 Mustang Center Console with
Like.
I have this one in Michigan, but it hasn't been cleaned up yet. The console lid will need to be replaced. -
Mmachattack replied to the thread Kind of ruined.Holy smokes, talk about hacking it up. Geeez
-
MNPD carries a replacement, or as Ryunker did, you can roll your own. I've seen them made out of 1/8" hardboard...
-
Mmachattack replied to the thread Parts Wanted Made CLOSE Thread.Hi, The reproductions are made of cardboard. I chose to make mine like hemi killer suggests. I used 1/8th inch masonite hardboard then...
-
MThat entire shift linkage setup is incorrect for a 71-73. Given the mess that Edelbrock creates for their Ford kickdown setup, I...
-
Mmachattack replied to the thread P/S pump replacement a dud -- what now?.Bench test the pump before the install. Fill the reservoir and Use a larger chuck drill run the pump. Extend the pressure side tube...
-
Mmachattack posted the thread In need of a Amp gauge * I found a gauge* Thanks everyone in Electrical, Lighting & Electronics.Hi everyone, Im in need of a "core" amp gauge from the center 3 gauge cluster. It does need a good needle, and face but doesn't need to...
-
Mmachattack replied to the thread Shout out to Motorcity Mustang.Same........Hes a straight shooter all the way! His help to me has been over the top! Thanks Mike for all you do! Rod
-
Mmachattack replied to the thread Help with the Speedo gear.Thanks you guys! That was more than helpful ! Got that little jewel ordered. Now if I get a ticket? its my fault :-) Rod
-
MThe speedometer cable needs to rotate at 1000 rpm at 60mpg. My info shows 8 teeth on the FMX output shaft. A Cooper Cobra 275/60R15 is...
-
MThis should help you with your question. https://www.tciauto.com/speedometer-gear-calculator
-
MHi, I changed my gear ratio to 3.50 gears. I have a Fmx Trans with a 351c. 71 mach. Also a rear tire change to 275/60 r 15 Can...
-
MHowdy machattack! I've been trying to remember how I did the door lock holes and I think I used a step drill for the hole. I can't...
-
MHi Sheriff, Some time ago you posted about the M and M door panels. Im ready to cut in the door handle cups today but had another...
-
-
Loading…
-
Loading…