Recent content by roadking

I had already called this company. They're located in Van Nuys California and they want $400 for a reconditioned set with core exchange. Seems a little steep to me so I thought I'd ask you guys. Thanks

I need to replace the 50 year old motor mounts on my '73 Mustang Mach 1. It's got a 351c 2v H code under the hood. Where is the best place to purchase a new set from? Apparently the type I find the most is the DEA A2257. Am I better off getting the aftermarket from wherever or try to get my...

Thanks, I appreciate the input and knowledge, with that being said I think I'll swap it out for a new one!

I have a question for the group. I have a '73 Mach 1 351c 2v and I pulled the oil pan to swap it out (big dent at the front) and since I did I was wondering if I should exchange the oil pump? As far as I know it's the original oil pump and I always had good oil pressure. There was a lot of...

I went with 235's all the way around on Cragar's - 15 x 8's with 4 1/4 back spacing. Had the width of my finger between the sidewall and the spring on the front end. 245's might have been too close? Sent from my SM-G900V using Tapatalk

I'm going to upgrade my tires and wheels on my 73 Mach 1. Currently I have 14's (steel wheels and Ranger wheels) and am looking to upgrade to a 15's with Cragar's! This is going to be a daily driver, so how wide of a tire would work best and have that meaty look it? Any suggestions would be great!

Hello, I've got an 1973 Mach 1 351C 2v H code, motorcraft 2100 carburetor with an FMX tranny . It's in need of repairs and restoration which I've been in the process of getting to here and there. Interior is a big project and also cleaning up under the hood (makeshift wiring and such) and...