turtle5353

That little c4 will take a pounding. Mine has been through 3 different motors in my car and I still shifting great. Started on a...

I really liked my Scat Stroker kit. Very nice parts.

I sprayed raptor liner in the wheel wells, floor pans and trunk of the 71 I restored. I really like it.

Here’s a picture of the cribs like my buddy uses when working on his Vette(obviously not the vette😁). If you build them sturdy, and use...

I did what grandma has pictured above.

Couldn’t afford a 70! Lol. But the car has grown on me over the years.

I can’t remember what all the letters stand for but you have 2.79 gears.

Measured for and ordered my new pushrods.

If I could find a car in that shape for $5k. I would buy it in a heartbeat and throw all my good parts on it and paint it. I can’t touch...

I run NGK plugs in my 408.

I did not. If you follow the instructions to the letter, they have you install a set of intake gaskets that block off the heat...

Crank and rods caps. Heads and intake. Other than those items not much else.

93 is at virtually every gas station in PA and OH

I went with the slightly thicker custom head gasket from cosmetic to get my squish where we wanted it.

We built this motor about 10 years ago. If I remember correctly compression was around 10.5 I am running a Torker II intake and my...