Search results

I bought some cheap mechanical gauges with a voltmeter as I hate electric oil and temp gauges. Only needed +V, GRND and Light wires. Paul

So a repop bezel is $200 from ebay delivered sounds high but I paid $80 for mine and it arrived broken at the top with the woodgrain pretty cooked. So now the $200 doesnt sound so bad IMO. Good Luck Paul

Exhaust Apart? X-Pipe? Trying to stab the engine back in with the trans in place is a serious headache unless its an automatic. Either pull the trans or pull the engine with it. If you get the adjustable engine sling its a breeze with the help of a floor jack under the trans! Good Luck Paul

The hose goes through the floor and abt 3/4 OD You could see it by crawling under the passenger side I assume non ac cars have it too my car has ac. Paul

The heater box has a drain tube that goes through the floor near the hump so a leaking core may not show inside the car. Paul

I have enough parts and material to make a few, if anyone is interested PM me. The price is $79 Delivered in USA. I will make your map light as I find the time and send you photos before you pay via Paypal. I will accept returns if you don't like it for whatever reason. ( buyer pays return...

Prototype wired and done. Sending out to 73 Pony this week. Paul

Yes Sir I understand! Your power side mirror tutorial is off the charts awesome! I'm not sure how many people can pull that off with the garage tools they have. (wish I had a garage) The original switch is (on) (on) type. My switch will be (off)(on)(on) for those that want to wire it with...

Good point. Running it on a half dead 9V it's not bad I could find my ign key Ok and it lights up the center area. I doubt it's as bright as the incandescent bulb like the original. The original I have doesn't work so I cant compare. I should add that the switch I install will be three...

Hey Guys (And Gals) I was lucky to get an original Map Light from a member here for cheap. Instead of installing it and be done I decided to clone it and make it available to anyone who would like a clone. The ML is made of .125 ABS with camera case finish which is slightly thicker than the...

most common mistakes; using sealer on cork gaskets. over tightening bolts. using rubber end seals instead of "The Right Stuff" Paul

Most all cars had a heater control valve to stop hot coolant from entering the passenger compartment when the heater is not in use. If you heater hoses are connected than you are circulating hot coolant through the heater core at all times. There was a heater control valve on your car...

I was told many years ago that the hose supplying coolant needs to have the heater control valve installed on it. The reason was that when the car is fired the heater core will get SLAMMED with coolant and will stretch the tanks and lead to early heater core failure. I always fire the car...

I got some Monroes from rockauto no issues would recommend. Paul

Duel Feed I like the quickfuel gaskets they are better than Holley IMO On the ebay carb check the list number stamped on the horn to this page; http://documents.holley.com/techlibrary_carb_numerical_listing.pdf When you get a carb see if the jets match that page as well Paul

I got a nice used Holley 750 DF DP off ebay for 220 delivered and spent 50 on a quickfuel rebuild kit. No complaints Paul

Can someone post a photo of the part or e-mail a photo to me I may need one. Thanks Paul [email protected]

Holley 750 DF DP is what I run and Recommend. Paul

clips are nothing special and are available on the net Paul

PM Sent to Judge