DIY Shock tower brace and Monte carlo bar

Robsweden · Mar 21, 2021

Don C said:
Nice. The tubes sure clean up the engine bay. The stamped steel OEMs don't look good and are always in the way.

Too bad you're so far away, I'd have you make some for me. Oh well, I've been wanting a new welder, mine is about worn out, repair parts no longer available, good excuse for buying a new one.

Thanks Don, Buy a new welder and get busy building one

Fabrice · Mar 21, 2021

Very bra Rob! Sure looks good!

mach71351c · Mar 22, 2021

Nice job!

Robsweden · Mar 22, 2021

Fabrice said:
Very bra Rob! Sure looks good!

mach71351c said:
Nice job!

Thanks Guys

timachone · Mar 22, 2021

Wow Rob, that looks really good and strong forever! Very well made! Although I am a OEM guy I must admit yours look a lot sturdier and more praticable - well done :thumb:

Robsweden · Mar 22, 2021

timachone said:
Wow Rob, that looks really good and strong forever! Very well made! Although I am a OEM guy I must admit yours look a lot sturdier and more praticable - well done :thumb:

Thanks timachone