Need a schematic for shifter & tilt

[Carolina_Mountain_Mustangs]

Well the old memory is about gone, lol. I took the steering column and automatic shifter out of my 73 vert last summer. Well really I gutted the interior removed the top and did a deep detail. I am ready to install the console but I cannot find detailed instructions in the Ford manuals on how to get the shifter back together. I took the tee handle off to clean everything and do not know how to get the cable hooked back up inside??? The car came with FMX but po put C4 in.

Also when I was going through my left over parts I found a tiny spring and a plastic sleeve that I remember came out of the tilt column. Again the Ford shop manual does not show all the parts. There were also a couple steel shims that I also think came out of the tilt column where the rack gear for ignition switch runs but just do not know.

Does anyone have an exploded view of both the shifter and the tilt column showing all the parts?

When I got the seat belts back in the seat belt buzzer works, lol. Now if I just had a shifter and steering column.

Thanks for any help.

 

[piper62j]

Go here..

http://www.7173mustangs.com/thread-tilt-steering-help

 

[Carolina_Mountain_Mustangs]

Go here..

http://www.7173mustangs.com/thread-tilt-steering-help

Ok that is what I needed for the tilt. I see the little spring and plunger goes under the bail wire looks like. Don't see the shims anywhere.

Thanks for the link.