Guess my dyno numbers (RESULTS ARE IN)

7173Mustangs.com

Help Support 7173Mustangs.com:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
I am looking forward to the power chart. My setup is very similar to yours except that I have a little less compression at 9.7. My cam also has a little lower lift but a little more duration.

 
I am looking forward to the power chart. My setup is very similar to yours except that I have a little less compression at 9.7. My cam also has a little lower lift but a little more duration.
Here is the sheet. Guess my guy miss quoted on the torque. Still very happy with the results.

Screenshot_20210702-145013_Write on PDF.jpg

 
Last edited by a moderator:
That's a very nice flat torque curve.  You should really enjoy the ride!

 
Thank you. This is awesome. Since we have similar setups can you post the complete specs for your cam.
Sure, it's a Crane hydraulic roller and the specs are adv dur 286/294 @.050 224/232 with a lift of .586/.609

super impressed with the stock open chamber heads. Just did a 30 mile run yesterday with is my longest so far. It's just pulls! Cruising in 5th a 60 is nice also. RPM is around 2K with the 3:89's and .82 final gear ratio in the trans.

 
Back
Top