Hemikiller

Important part is if it has the correct shift shaft on it.

The TMI is a much better match to the original than the other ginger door panels I've seen. I don't know who made them, but the "repeat"...

The body side protection moldings are bright dip anodized aluminum. They can be straightened and polished, or polished and re-anodized...

This is Pancho, our rescue. and Wahlberg, our other rescue

Overall, it looks well done. I've seen much worse examples of butchery. His car, his choice. I'm not a fan of the carbs through the hood...

You're right, I would never EVER remove the factory radio aerial from my car!

1 - agree with Chuck, you'll likely need an MSD 8920 tach adapter. The 71-73 factory tach is current driven. 2 - I replaced all the...

The 72-up specs in that chart are very close, but I wouldn't trust the 71-earlier numbers. If you actually do the math, you'll never hit...

I created this a while back

We have a classifieds section https://7173mustangs.com/discussion-forum/71-73-mustang-classifieds.16/

I reset the odometer to 0 when I restored my '71. ¯\_(ツ)_/¯ Simple solution is "true mileage unknown" or just run with whatever is on...

205-210 is not "hot", that's normal operating temperature. Thermostat ratings do not dictate the running temperature of the engine, that...

Standard '73 Q-code / 4 speed axle ratio was 3.50. 3.25 was the only other option.

Nice find! Is that the car from Colorado that was on the FB groups a while back? Marti drives me nuts with how they lay out the...

S on the wiring diagram is a splice. Those two wires are permanently connected within the harness.