I guess that also means I am still looking for a pair of exhaust manifolds for a 351C 2V or if someone has just the Right(Long) side I know where I can get the left from. Please let me know if you have any. Thanks.
Hey All! Just wanted everyone to know and watch out for this, I got a Message from Roland01 offering me a set of Exhaust Manifolds that he had on EBay. Said he would pull them off of EBay and sell them to me for the asking price but include shipping because I was on this forum. There were a...
The previous owner of my 72 coupe put new motor mounts on just a few months before I bought the car. However, when I pulled the engine out the drivers side mount was already broken. I was looking at different kinds of motor mounts and someone suggested using a torque strap. Has anyone here...
Looks like they are about 30lbs. FedEx at the slowest Express Saver rate looks like less then $50 shipping. However, I was just guessing at your zip. Mine is 78240. How much would you want for them?
Does anyone have a good set of exhaust manifolds for a 351C/2v engine? I was going to have mine ceramic coated, but once I got them out I realized they are full of cracks. Some of them you can even see light thru the cracks.
Hey everybody,
It's been awhile since I have posted anything. A year ago I pulled the engine (351C v2) out of my 72 hardtop as the car went off to get painted. It was a running engine at the time so I was just planning on cleaning it up and getting a fresh coat of paint on it, However...
If you have a later 71 and you have just a single radiator to grille support bracket instead of the two that Matt showed in the post above I would be interested in it if he is not.
Thanks,
Lance
I can't seem to find a description or part number for it anywhere. I'm not even sure what to call it. It's the tall vertical support that is under the Hood latch and bracket. This pic is from the "72 car shop manual volume IV Body".
I am in need of a replacement. If anyone could assist me...
I have two body panels up for sale.
Re-pop front passenger fender was bent in shipping, (four inches of the top back corner are bent at a 90deg angle and the front corner from the bottom of the wheel well to the upper front corner are creased badly. Maybe the rest of the sheet metal is the...
I found that there was a vacuum port running from the front side of the intake manifold but the hose attached to it was stuck onto a hex shaped end of a bolt on the carburetor. That had to be a really good seal, lets put a hexagon in a round hole and hope none of the air gets by. :-/ I was...