Search results

I have sent my Ford AOD to Monster transmission, Has anyone used these guys and what was your experience? They will be building it to there ss model to hold 600hp/550ft.

Ok, im new to the mustang world so your info would be great. I have a 72 mustang that I bought in pieces, so I found a cheap 351c stock 2v with a fmx trans attached. I never seen or heard it run, I installed and it run great, BUT it had a crazy vibration off idle.so I pulled trans and found it...

ok, Im just getting to the point where I am able to drive my car, now on its first run down the street, I have one issue, the lights are on for about 10-15 minutes then just go out. I then can shut them off and turn them back on and they then stay on for about 3-4 minutes then go out. and they...

Ok, im still assembling my car and I have started the front clip.  I bought this car in pieces as a rusted shell with boxes of junk parts in it and have no other one to look at for a reference, Can anyone tell me where the front fender supports go, I bought new ones but not sure where they go...

My 72 vert is going together ok at this point but I have installed the tail lights and the turn signals only work if I work the handle by hand, they will blink fine if I do it by hand but don't work on there own, I replaced the blinker relay and still nothing, Also I have no break lights, all...

LOOKING TO SEE WHAT OTHERS HAVE FOR DISTRIBUTORS AND COILS ON THERE CLEVELANDS, IS WHAT YOU HAVE WORKING GOOD AND IS THERE ANYHTING SPECIAL YOU HAD TO DO TO GET THEM TO WORK PROPERLY?

Ok, I have a 72 convertible I bought as a project in pieces, I have put a Cleveland in it and trying to figure out some wiring in the engine compartment, I have a plug, at the fire wall that has 4 wires coming out black with white dots, red with white stripe, red with green stripe and red with...

Any suggestions on wheel backspacing and offset, I bought tire for my 72 convertible and waiting to order wheels to see what I want, tires are rear 255/50/17 and fronts are 255/40/17. im looking at the American racing wheels vn501 in the 9-9-1/2 wide rang, any suggestions on spacing? im trying...

what are your thoughts on the aftermarket nasa hoods?  I have an original hood but it is in need of a lot of work, Do repair or replace with aftermarket? Has anyone had any problems with them?

Need some advice, I have a 72 convertible with 351c that is being bored and stroked to 393, This has not ran yet, still in restoration phase.do you think I need to strengthen the frame up and if so do they sell a kit?