- Joined
- Jan 13, 2012
- Messages
- 1,989
- Reaction score
- 8
- Location
- Washington
- My Car
- 1971 Mach1, 351 Cleveland, Ram Air (not factory), C6 Automatic, AM/8 Track, Bright Red.
I finally put an epoxy floor covering on my garage and I have to say it was a snap and it really turned out as advertised. I only did one parking space to start off with "just in case". I put it on two weeks ago and tested a portion today to see how well it's attached to the concrete and it's tough, it won't scrape off like paint and it filled in and covered the hair line cracks, so I'm going to go ahead and do the other two parking areas.
I used Rust-Oleum Epoxy Shield, it came with the acid etcher needed to prep the concrete. The hardest part was getting everything off of the floor then really scrubbing the concrete to remove all stains prior to applying the acid to etch it.
You can see where I cleaned and acid etched about foot over into the other parking area that hasn't been epoxied yet. Anyone have any long term results with this stuff?
Jim
[attachment=19223]
I used Rust-Oleum Epoxy Shield, it came with the acid etcher needed to prep the concrete. The hardest part was getting everything off of the floor then really scrubbing the concrete to remove all stains prior to applying the acid to etch it.
You can see where I cleaned and acid etched about foot over into the other parking area that hasn't been epoxied yet. Anyone have any long term results with this stuff?
Jim
[attachment=19223]