Radiator support wiring clips - Where do they go?

[bdennis]

Hey guys,
Not long ago I removed the grill, bumper, stone tray and head light assemblies to clean up the parts and repaint the parts and radiator support panel.
My Mach1 is a fairly original, unmolested car and I like to put things back to the correct place or put things right.


When I removed the wiring and clips so I could paint the radiator support, I remembered where the long black wiring clips go but I don't recall where the smaller clips go.
Can someone advise where these should go and what part of the wiring to the front lights they should hold down? I have 4 of them. Per the pic below, the black one is for reference from a wiring tiedown clip kit I have.





Im confident that the black loop one is in the right spot, but I believe the yellow one is not in the correct place?



Any info / help would be appreciated.

 

[Omie01]

I believe 2 of them hold the wire harness to the side marker lights of the fenders, I can't remember where the other 2 would go.

 

[tony-muscle]

I don't know if they are the same, but there are two on the "engine" side of the radiator cross brace.

 

[dawson357]

This is a photo of the wire clip from my 73 Grande attached to the side marker.

 

[Stanglover]

If it isn't a concours car, I'd put them where I felt they were needed. The old clip/strap type are likely broken anyway. You can replace those easily enough. I wouldn't overthink that stuff.

 

[bdennis]

Thanks for the Pic Dawson357. That helps.

Geoff,
It is not a concours car but I like things to be "right" for my own sanity. So all good. Thx.