Hemikiller

That's bizarre. The WER rear axle was used in the full size Fords as the "light duty" axle. Had no clue that they also used it in the...

My first one was the low-line Shelter Logic "Garage in a Box" from Tractor Supply and that lasted for a couple years until we had a...

They have a two year warranty, but the other one I have is eleven years old and still doing fine. I'm certain it wouldn't last nearly as...

Erected a new Rhino Shelter hoop house as temporary winter storage and work space for the Galaxie sportsroof. It won't fit in my garage...

I recently saw a set of non-GT 70/71 Torino taillights in one of our cars, it looked okay-ish. Maybe check out Long's Customs, they're...

If your '73 is original, it will have an EGR spacer plate under the carb. The EGR can carry a lot of heat into the carb, which...

You didn't say which engine you have, but like Don said, the factory 351C are simply bolt down and torque to spec. 302 rockers are also...

From everything I've read, the mounts were set at a different angle to deal with a vibration specific to the the convertible body...

The problem is the convertible mounts aren't available. *Supposedly* Dan at The Mustang Barn can make a set of the correct convertible...

71-72 hardtop/sportsroof frame stands with two Anchor 2257 mounts

I'd be happy to do that work, sure beats welding in new floors.

Grease your u-joints, If it still makes the same noise, then you'll need to look at the differential. You might have a pinion bearing on...

Those were crimped into the panel. I'd get some square nuts and weld them into the holes.

The 6915 fit without any issue, no dinging or denting of tubes required. The 6921 look nearly identical in the way they are fabricated...

Dental floss or fishing line for the letters. The quarter trim looks like two clips with nuts and a bunch of sealant coated screws...